Warnings:
The Staubar is not to be used in a game.
The Staubar is designed for on ice training only.
Serious injury can occur if the Staubar is not worn with a chest protector.
Never attempt a ‘deck’ or double-pad stack save while wearing the Staubar.

Fitting

Staubar Classic Belt adjustments

1. Measure the circumference of your chest with your chest protector on. This measurement should be made about five inches below the neck of your chest protector.
2. Next, to determine the length of the underarm straps, take the circumference measurement from step 1., and adjust each strap to 1/2 that measurement. (Example Circumference = 48" each strap should be 24" from the strap end to the loop on the back of the belt assembly). Adjust each underarm strap to length. The tri-glide belt adjuster should be adjusted as close as possible to the loop on the back of the belt assembly.
3. The shoulder straps should be adjusted for the proper alignment on chest. The belt should place the bar midway between the shoulder and elbow. The top of the belt is position correctly when the distance between the top of the belt and neck of the chest protector is about five inches.
4. The shoulder pads should be adjusted to maximize comfort on neck. However the shoulder pads are not required and can be removed. Excess shoulder strapping can be looped back under the shoulder pads.

Notes:

1. To take-up excess underarm strapping for goalies smaller than 36" chest. Loop the straps through the slots in the back support of the belt. Loop from the outside to inside this keeps the loop and belt adjuster from directly contacting the players back.
2. The belt must be tight and the bar must be placed above the elbow to function correctly.

Instructions for use

1. After putting on your chest protector and practice jersey. Place the belt over your head with the bar mounting assembly in the front of your body and the back support straps in the back.
2. Reaching with your left hand pull the left side strap towards the front of your body routing the strap through the metal loop on the edge of the belt. Pull the strap to the right edge of the bar support flap under the Staubar logo. Secure the Velcro to the front of the belt.
3. Next, reach with your right hand pull the right side strap towards the front of your body routing the strap through the metal loop on the edge of the belt. Pull the strap tight and secure the Velcro to the front of the belt. The strap should come close to the left edge of the bar support flap under the Staubar logo.
4. Attaching the bar, pull down the flap with the Staubar logo on it to expose the mounting plate assembly. Position the bar with the arm cradle ends up. Align the bar pins with the holes in the mounting plate and push in.
5. Finally, pull the bar flap over the bar and secure by connecting the Velcro.

The Staubar should be worn over the chest protector and jersey. It should be adjusted so that the bar is approximately 2"above the elbow.